Depending on the design of the awning their lower mounts will be approximately two to four inches beyond the edges of the window or door casement.
Attaching awning to fascia.
With a 1x4 fascia board the awning can be mounted as in the instructions that come with the awning.
Patio cover attachments available for wall fascia or eave of roof roof top or freestanding.
Your homes fascia board needs to be properly secured to the rafters the use of a 90 degree bracket will create a mechanical connection these a34 clips can be purchased locally and are very inexpensive.
How to attach a patio or verandah to a house 1st option.
May not be installed correctly 2.
Attach the horizontal beam by using a nail gun.
After that to make it flush with the roof of the existing house cut the two outer rafters.
With a 1x4 fascia board the awning can be mounted as in the instructions that come with the awning.
0 00 attached below original gutter on fascia 2nd option.
Attach a header board to the fascia the existing fascia board may be strong enough to hold the pergola but it is easier to reinforce the fascia by attaching a 2 x 8 header board to it.
You have to do it thoroughly so that the rafters sit flush on it.
The clips attach to the back side of fascia board and side of rafter.
Posts bolt to slab or footings for attachments to the wall fascia or roof top where freestanding doesn t need another structure for support however posts must be poured into concrete on freestanding aluminum awnings.
This allows most awning fasteners to puncture the concrete lap siding and sheathing and make contact with the studs.
Hi john personally i would not just screw hooks or eyes into the upvc fascia as it 1.
Drill holes into the header board and fascia board and attach using the 3 8 inch lag bolts and washers.
Roof overhang with closed soffit.
Using a stud finder locate the full left to right width of the header and axial studs.
Option 1 mounting the awning rail and upper brackets to the fascia board.
The canopy could pull the fascia down or crack it.