Attaching Hardie Siding

Fasteners shall be installed between 1 in.

Attaching hardie siding.

You have two options here you can make your own or you may be able to find acceptable prefabricated third party starter strips available for purchase. Never place a fastener less than 3 4 inch from the top edge of the plank. We have dozens of installation specialists throughout the u s. Hardie board siding is a cement board siding that can be installed over braced wood or steel studs on the exterior of a building to provide a strong durable covering that creates the look of wood siding without the expense or maintenance requirements.

Store flat and keep dry prior to installation. The siding is installed using the same general techniques as wood siding with planks layered up the side of the building and nailed securely into place. As a homeowner you will work with a contractor who will facilitate the installation of your james hardie siding trim soffit wrap and flashing products including products with colorplus technology. James hardie is the inventor of hardie siding.

The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly and will lose track of where the nails are going. Installing siding wet or saturated may result in shrinkage at butt. Hardie siding has long lasting baked on color and is resistant to weather extremes. James hardie recommends the use of building paper type weather resistive barriers with all siding products.

Hardie plank siding is almost always installed with air nailers which are the best tool for quick installation. James hardie recommends installing a rainscreen an air gap between the hardiepanel siding and the water resistive barrier as a best practice. From the top edge and no closer than 3 8 in. Hardie siding increases the value beauty and durability of your home.

James hardie will assume no responsibility for water infiltration within the wall. From the ends of the plank. James hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above.